Hydraulics | Ferguson Enthusiasts 2/5

Articles

Sep 30

Stuck Hydraulic Lever

I have an opportunity to purchase a TO-30 which checks out fine except for the following: The 3 point hitch control lever is frozen in...

0 views0 comments

Sep 30

Strengthened Lift Cover for 2500 Pound Pressure Relief Valve

I installed the 2,500# Pressure Relief Valve (PRV) in my F-40 at the urging of my supplier. The Changes Section of the repair manual...

1 view0 comments

Sep 30

Slow Lowering Lift Arms

I have a 1949 TO-20, which I am going to have restored this winter. Before I do that, I need to repair the hydraulic system. The problem...

0 views0 comments

Sep 30

Slipping Quadrant Friction Washers

I have a Ferguson TO-35 and I’ve had the tractor for over 15 yrs. This last summer the 3 pt hitch began acting funny. When I raise the...

0 views0 comments

Sep 30

Silver Mist Grey Hydraulic Quadrant

The quadrant, adjusters, and stops on the F-40 hydraulic cover I am rebuilding are rusted, poorly painted, and definitely not plated,...

1 view0 comments

Sep 30

Replacing F-40 Cross-Shaft Bushings and O-Rings

After replacing the Bushings, and O-Rings on my F-40 Cross-Shaft, I wonder if this service can be done without removing the lift cover?...

0 views0 comments

Sep 30

Removing Rusted Control Spring Adjusting Yoke and Lift Arms

I am working on a TO-30. It seems every part is either worn pretty well or rusted to the point of being nearly impossible to remove. The...

3 views0 comments

Sep 30

Recommended Hydraulic Oil Weight

I have to drain the fluid from my 1952 TO-30 to replace the PTO shaft. What do you recommend to refill it? October 20, 2014. The...

2 views0 comments